KAESER KOMPRESSOREN EPC 150-2-G, Сборка и руководство по эксплуатации

Страница: 18 / 100

➤ Mark the oil that your compressor contains in the table below.
Standard oil Special oil
EPC 150-2/
EPC 230-2
EPC 420-2 –
EPC 1000-2
Oil type SAE 5 W30 VDL 150 FGP
Application Standard oil for all ap‐
plications except in
connection with food‐
stuff.
Standard oil for all ap‐
plications except in
connection with food‐
stuff. May contain
traces of silicone.
Specially for use in
compressors where the
air may come into con‐
tact with foodstuff.
Oil contained in my
compressor
Tab. 14 Compressor oil recommendation
2.10.1 Compressor oil charge
Compressor model Total charge [litres] Topping up volume [l]
(minimum–maximum)
EPC 150-2-G 1.1 0.25
EPC 230-2-G 1.1 0.25
EPC 420-2-G 1.4 0.22
EPC 550-2-G 1.4 0.22
EPC 750-2-G 1.5 0.37
EPC 1000-2-G 1.5 0.37
Tab. 15 Compressor oil charge
2.11 Electrical connection
Basic requirements
The machine is designed in accordance with the conditions for an electrical power supply specified
in EN 60204-1 (IEC 60204-1) section 4.3.
If no other conditions are specified by the operator, the thresholds described in this standard must
be adhered to.
It is recommended that the user and the supplier reach an agreement on the basis of EN 60204-1,
Annex B.
Check and adjust for other deployment conditions before commissioning.
If the machine is supplied with a mains cable and a plug, the power socket may be fused at
the nominal current of the plug device.
2.11.1 Three-phase power supply
The machine requires a symmetrical three-phase power supply.
In a symmetrical three phase supply the phase angles and voltages are all the same.
This machine may only be supplied from an earthed TN or TT three-phase supply in which the
neutral point is earthed.
2 Technical Specifications
2.11 Electrical connection
8
Assembly and operating manual 2-stage piston compressor
EPC-2-G
No.: 9_5753 24 E