Country-
spec. Set-
tings
Level Display/
settings
Action in this menu/meaning
4
1
2
3
4
History
NOTE: Displays all of the actions performed in the system and
on the web interface.
4
1
2
3
4
Account Management
1. Enter your User name.
2. Enter your new user-defined Password.
NOTE: The following is specific to KACO: Following initial
start-up, it is necessary to
Change password
4
1
2
3
4
Restart the Device
NOTE: Transfer safety-related parameters to a storage
medium.
F
If necessary, re-start the device.
NOTE
With regard to the selection of country settings, KACO new energy attests:
1. that the relevant certificates are only valid if the corresponding country settings have been selected.
2. that all configured grid parameters must be configured in accordance with the requirements of the grid op-
erators.
3. that the configuration of parameters using IEEE 1547: 2003 table 1 is possible but is only permitted if it is
requested by the grid operators.
9.5
Monitoring the device
↻
You have connected the device to the network.
1. When using a DHCP server: Activate DHCP.
2. For manual configuration (DHCP off):
3. Open the Settings/Network menu.
4. Assign a unique IP address.
5. Assign a subnet mask.
6. Assign a gateway.
7. Assign DNS server.
8. Save your settings.
9.6
Carry out firmware update
NOTE
Ensure the active DC power supply of the device
It is only possible to update all of the device’s components to the most current firmware version in this operat-
ing state.
NOTE
The DC power supply must be guaranteed during initial start-up.
8
The sequence of the settings required for initial start-up is preset in the configuration assistant.
8
It is only possible to configure the grid parameters with DC voltage. The further parameters can also be config-
ured with a present AC voltage.
Manual
Configuration and operation | 9
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137 TL3-S
Page 63
EN-US
