Page 7
KACO blueplanet 3.0 NX1 M2 KACO blueplanet 3.7 NX1 M2 KACO blueplanet 4.0 NX1 M2
KACO blueplanet 5.0 NX1 M2
By clicking on “Inverter’s Parameter Setting”, you can set the inverter parameters. No passcode is required for the first use of
these parameter settings during the initial inverter commissioning. If the inverter parameters need to be changed after the
initial commissioning a passcode will be required. The inverter specific passcode can be obtained from KACO Service.
Fig. 14:
Inverter passcode
3.2.2
Enabling Inverter functions
All required inverter functions can be activated by enabling them as shown below.
Fig. 16:
Inverter function enable/disable
