Translation of the original operating manual for the KTS SpeedTec mini
B|HM0SM|00001|V0006|EN
Page
28
5.6 Start (operation)
Use the “Start” button (see 5.5) in the main menu to bring up the “Operation” interface (Image 1).
The yellow arrow keys can be used to navigate through the steps. On the first line, the program
name can be entered and the program number read. The current step is indicated on the line
below. A green background is used for the current step. Programs can only be edited with the
“Edit” switch set to position 1 (see 5.7).
Actual length:
Here, the current winding position for the taping unit
is displayed.
Taping parameters:
Start position
Distance [in mm] from left-hand connector to
point where taping process is started
Initial layers
Number of tape layers (non-angled windings) at beginning of taping process
Length
Overall length of tape
Speed
Speed [in %] at which the taping process is performed
Feed distance
Traversing distance [in mm] of the taping unit per line-set revolution
Final layers
Number of tape layers (non-angled windings) at end of taping process
Overrun position
Point beyond end position for overrun, allowing tape to be properly aligned and correctly
cut at end of taping process.
Final speed
Speed at which overrun position is approached and final layers are applied
Tensile force
Tensile force (in N) with which the line set is tensioned in the right-hand clamp
Winding aid
Speed of winding aid as fraction of speed of winding head, expressed in %