Kaba PAXOS advance Series, Руководство по установке, Страница: 26 / 62

26 II_PAXOS_V001_20161007_EN PAXOS advance Series
Installation Installation Instructions
4.4 Mounting the locks
Important information on mounting the locks
When mounting the locks in the boltwork, it must be ensured that the lock bolt can move freely
up to the end positions of the adjustable stroke and that the shifting force works only in the axial
direction (direction of movement of the lock bolt).
Lateral forces should be avoided as far as possible and must not obstruct or limit the movement
of the lock bolt. The lock bolt must be guided or supported in the event of asymmetric lateral
locking.
The lock bolt shifting force has a nominal value of 30 N over the mechanical life-time of min.
10,000 cycles. The lock bolt can withstand a static force of at least 1000 N.
There must not be any breakthroughs within the immediate vicinity of the lock (mounting surface
of the lock). Any such breakthroughs must be sealed accordingly or secured by a different means.
If this is not done so, approvals (e.g. VdS and UL) may lose their validation.
The lock must be mounted on a level surface or onto four level mounting points.
The lock(s) can be installed on all materials that provide sufficient anchorage of the components.
Metal materials are preferential.
The locks are available in two different lock classes:
–
Lock class B/C (according to EN 1300) or class 2/3 (according to VdS 2396)
–
Lock class D (according to EN 1300) or class 4 (according to VdS 2396)
Important: per locking system only locks with the same class must be used!