K2L OptoLyzer MOCCA compact FD, Руководство пользователя

Страница: 17 / 33

OptoLyzer MOCCA Devices
© 2017 - 2018 K2L GmbH & Co. KG 17 DS60001526B
K2L USER MANUAL
Table 5.1 Connectors on the Front Panel
INTERFACE SYMBOL DESCRIPTION
Analog Audio OUT The OptoLyzer MOCCA compact FD device provides an analog audio
out interface (a stereo headphone output). It has a 3.5 mm jack plug.
Output Power: P
o, Max, Rms
= 1.4 mW (at R = 16 Ω , V
out
= 150 mV
RMS
)
The bandwidth (16 bit mono/stereo or 24 bit stereo) specified for this
interface is also used for the S/PDIF OUT and vice versa. Rx and Tx
transmission must cover the same bit number per channel. Refer to the
S/PDIF description inclusive examples in Table 5.3 on page 20 .
ECL ECL can be used to start a diagnosis process over the MOST network
according to different ECL implementations. For the pin out refer to
Section 6.9, "Trigger/ECL," on page 26 .
MOST (cPHY) The MOST150 network connectors base on a coaxial electrical physical
layer (cPHY) described separately below.
For the pin out refer to Section 6.10, "MOST Network Connector," on
page 26 .
MOST (cPHY
Rx connector)
The connectors base on a coaxial electrical physical layer (cPHY). This
connector provides an Rx interface. It is used

in simplex use cases as Rx (indicated by the single-headed arrow).
MOST (cPHY
Rx/Tx connector)
The connectors base on a coaxial electrical physical layer (cPHY). This
connector provides a duplex interface (Rx/Tx connection). It is used

in duplex use cases as Rx/Tx (indicated by the double-headed
arrow).
MOST (cPHY
Tx and Rx/Tx
connector)
The connectors base on a coaxial electrical physical layer (cPHY). This
connector provides a Tx or a duplex interface (Rx/Tx connection). It is
used

in simplex use cases as Tx (indicated by the single-headed arrow)
and

in duplex use cases as Rx/Tx (indicated by the double-headed
arrow) and

in duplex endpoint use cases (indicated by the double-headed
arrow).
Program Reset The device can be reset by the push button. If the button is pressed for
less than 1 s, the device is reset. The same button is used for switching
into the flashing mode if it is pressed for more than 2 seconds. For
details see the “K2L Flasher Online Help” that is part of the shipment.
Analog Line IN The analog Line IN input impedance is 10 k Ω . The analog input is
converted into a digital stream with resolutions of 16 bits / channel
(mono/stereo) or 24 bits / channel (stereo). It has a 3.5 mm jack plug. It
is possible to use either the Analog Line IN or the S/PDIF IN interface.
Rx and Tx transmission must cover the same bit number per channel.
Refer to the S/PDIF description inclusive examples in Table 5.3 on
page 20 .