K-Tech International, Inc.
56 Ella Grasso Avenue • P.O. Box 1025
Torrington Connecticut 06790 USA
1-800-993-9399
(860) 489-9399 • Fax: (860) 489-4399
Internet: www.ktechonline.com
Sales: [email protected] • Support: [email protected]
Page 1 of 2
Tools Needed
Only requires tools to access telephone circuit board - no tools required for actual programming
Tips & Techniques:
Programming Plus Model Phones
Sentry Plus (ET201, ET201A)
Liberator Plus (ET201A-LP)
Commander Plus (ET201-OEM, ET201A-OEM, ET201-OEMCS, ET201A-OEMCS)
Fortress Plus (ET1201, ET1201A, ET1201-MPB, ET1201A-MPB)
Connect
Telephone
Line shield to
true earth
ground using
supplied
Ground Lug
TELEPHONE LINE
RESET
BUTTON
LED
+
REMOTE
LED
+TIP
- RING
REMOTE
BUTTON
CHASSIS
GROUND
(phone line)
+
-
OFF-Site
Program
Board
Connect
Auto Answer
On
Program
On-Line
MICROPHONE
SPEAKER
VOLUME
1
2
3
7
8
9
4
5
6
Ý
0
#
STORE
PAUSE
MEM
Serial numbers 207200 - present
1. Verify that a working telephone line is connected to the screw terminals
marked PHONE LINE. Also verify TIP and RING polarity. (see
Tips &
Techniques: Telephone Line Measures
)
2. Determine the number to be dialed. If a “9” is required to access an
outside line, it is reccommended to insert a 4 second “Pause” before
entering the rest of the telephone number.
3. Program number as follows:
1. Place PROGRAM/ONLINE switch to PROGRAM position
2. Press the activating push-button
3. Press STORE, then MEM, then “0”
4. Enter the emergency telephone number to be dialed
5. Press STORE
6. Press the RESET button to shut the K-phone off
7. Place PROGRAM/ON-LINE switch to ON-LINE
4. Verify that the correct number was stored by pressing the activating push-button. The phone should
automatically dial and complete the call. Have the called party hang up; the phone should shut off.
Please note: If you have any further questions or problems, please feel free to call for Customer Support.
