K-array KB1, Руководство пользователя

Страница: 15 / 44

15 rev. C
KB1
A) CH1 TS (unbalanced jack) input. Use this input when using the module as
Right side in a stereo configuration.
B) CH1 XLR balanced (cannon) phantom powered input.
C) CH1 XLR link output. This is a direct physical parallel link ONLY to CH1
XLR input.
D) Mic/line Mode Selector. Mic Mode for mic level signals (-50 to -10 dB), Line
Mode for line level input (-10 to +14 dB)
E) CH2 TS (unbalanced jack) input.
F) DIRECT IN (MIXER OFF) Switch Button. When DIRECT IN is ON all the
DSP functions are bypassed, except for the Main LEVEL knob on the physical
Mixer Panel (see
S ) and the virtual Master Volume Fader (see C11 and D18 ).
N.B.: a KB1 in DIRECT IN Mode can only be used as the Right side of a stereo
configuration system of 2 x KB1. We advise against connecting any signal to
the KB1 serving as Right Side in the stereo configuration, other than the XLR
coming from the DI Out / Out R output of the main KB1 (serving as Left Side
of the stereo). In a stereo configuration all signals must be connected to the
Left Side module, where all DSP functions are active and DIRECT IN is OFF.
G) CH1 and CH2 Gain LEVEL Knobs regulate the amount pre-amplification
level of the corresponding input.
H) SPEAKER OUT NL4 (Speakon) Output. Connect to the Mid-High module
of KB1. N.B.: to ensure correct operation of the system, ONLY use a 4-way
Speakon connection.
I) CH2 XLR balanced (cannon) phantom powered input.
J) CH3 TS unbalanced (jack) Input for Line Level signals.
K) CH3 double RCA Input for Line Level signals.
L) CH4 TS (unbalanced jack) Input for Line Level signals.
M) CH1 and CH2 FX Send Knobs regulate the amount of signal to be sent from
the corresponding channel to the Effect Processor.
N) Aux Out TRS (balanced jack) Output.
O) Headphones TRS (stereo jack) Output.
P) DI Out / Out R XLR (cannon) Output.
Q) USB Remote Control plug for Remote Management via K-Framework
software.
R) POWER Switch Button.