15
3. Align the controller’s top and bottom edges with the card guides, and carefully slide
the PXIe-63985 into the chassis, as shown
4. Elevate the latch until the PXIe-63985 is fully seated in the chassis backplane. The
alignment pin on the rear of the latch can be threaded into the best fit alignment
port in the chassis rail.
5. Fasten the four mounting screws on the faceplate of PXIe-63985, and connect all
peripheral devices.
2�2�3 Replacing the Hard Drive or Solid State Drive
The PXIe-63985 provides a SATA 3.0 port with a pre-installed 2.5” SATA hard drive or solid
state drive. Replacing the HDD or SSD is accomplished as follows.
