15
All equipment must be protected from static discharge and physical shock. Never
remove any of the socketed parts except at a static-free workstation. Use the
antistatic bag shipped with the product to handle the equipment and wear a
grounded wrist strap when servicing or installing.
2�3�12 Installing the PXI-63980
1. Locate the system controller slot (Slot 1)
2. Depress the red locking lever and release the latch
3. Align the controller’s top and bottom edges with the card guides, and carefully slide
the PXI-63980 into the chassis, as shown
4. Elevate the latch until the PXI-63980 is fully seated in the chassis backplane.
5. Fasten the four mounting screws on the faceplate of PXI-63980, and connect all
peripheral devices.
2�3�13 Replacing the Hard Drive or Solid State Drive
The PXI-63980 provides a SATA 2.0 port with a pre-installed 2.5" SATA hard drive or solid
state drive. Replacing the HDD or SSD is accomplished as follows.
1. Locate the four screws attaching the drive to the bracket on the side of the PXI-
63980.
2. Remove the screws, as shown.
