JVC VR-X1600U, Инструкция по эксплуатации

Страница: 39 / 204

33
䡵
To close Management Application
1
Click [ (Close)]
2
Select [Save changes - restart services], and click
[OK].
Management Application is closed.
Caution:
●
Never turn off the power while saving settings of
Management Application.
●
When you change settings of Management Application,
restart the Management Application service; otherwise,
the new settings are not applied.
Connecting Cameras
Use the [Add Hardware Devices...] wizard to register
cameras in the network with the system and enable setup
and operations from NVR.
●
User name and password for each camera are necessary
for camera registration. Please check them in advance.
For details, refer to the instruction manual of the cameras.
Caution:
●
You need to configure an IP address for each network
camera in advance.
●
By default, the IP address for LAN1 is 192.168.0.253 and
the subnet mask is 255.255.255.0.
●
It is necessary to set the IP address of the network
camera in the same segment* as LAN1 of this unit. If the
camera and this unit are not on the same network, the
camera cannot be registered. Confirm that the IP address
of the camera and LAN1 are in the same segment. If they
are in different segments, consult your network
administrator.
Example: When the subnet mask is 255.255.255.0
IP address of this unit: 192.168.0.253
IP address of the camera: 192.168.0.100
* Segment: Underlined sections
●
Do not set multiple devices to the same IP address.
Otherwise, settings cannot be made correctly.
1
Click [Add Hardware Devices...]
The wizard will start.
●
Check to ensure that the [Express (recommended)]
check box is selected.
2
Click [Next]
Automatic detection of cameras connected to the network starts.
When the automatic detection is completed, a list of
cameras detected appears.
●
Depending on the network configuration, the camera may
not be detected automatically. Click [Rescan] when there
is any camera that is not shown in the list. When the
camera is still not shown, register the camera manually.
(
A
Page 115 "Manually Registering a Camera")
●
VN-C215U will not be detected automatically. Please
register it manually. (
A
Page 115 "Manually
Registering a Camera")
●
If the user name and password of a camera have been
changed from the initial settings, there is a chance that
the camera will not be automatically detected.