JVC VN-X35U - Network Camera, Инструкция по эксплуатации

Страница: 58 / 111

58
Setting Using Internet Explorer
PTZ Page
Set the movement for
A
Auto Return
B
,
A
Zoom Limit
B
and
A
Preset Position
B
.
This page can be used during access using
A
admin
B
or
A
operator
B
..
●
First of all, configure the encoding settings.(
A
Page 39)
●
Click [Advanced Settings] to display setting menu.
●
Click [PTZ].
●
Press the [OK] button to enable the new settings.
●
If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the
entry will be denied. Press the [Cancel] button to restore the invalid entry to the current value.
Note:
●
This feature can be used when the distribution size pattern setting on the Encoding page is set to
A
(MPEG4 only),
C
(MPEG4 only),
D
(JPEG only),
F
, or
H
. (
A
Page 39)
Setting (continued)
C
B
A
Click
A
Auto Return Restores automatically to the state specified under [Mode] when action is
not performed on the manually operated camera over the interval specified
in [Return Time].
Mode For setting the action after Auto Return.
None
: Auto Return disabled.
HOME : Returns to the home position.
Auto Patrol: Restores the auto patrol action.
Return Time For setting the time interval before restoring the action via Auto return.
[Set values: 1 minutes, 2 minutes, 3 minutes, 5 minutes, 10 minutes,
20 minutes, 30 minutes, 60 minutes]
Test Click [Execute] to perform a test execution of the preset Auto Return action.
B
Limit
Zoom Limit Set maximum value of electronic zoom feature.
[
Set values
:
1 , 2 , 4 , 8 ]
C
Preset Position
Speed For adjusting the speed of movement to the Preset Position.
This is also applicable to movement to the Preset Position in the Auto Patrol
mode.
Speed [Set values:Moment, Low, Mid, High]