18
8
[SYNC IN] Sync Signal Input Connector
This BNC connector accepts the input of an external
sync signal such as a composite video (VBS) or black
burst (BB) signal. When a sync signal is input into this
connector, the camera operation is automatically
synchronized with the external sync signal.
The 75-ohm termination of this connector can be
switched on/off on the menu screen as required.
9
[VIDEO OUT] Video Signal Output Connector
This BNC connector outputs a composite video signal.
Connect this to the video input connector of a video
mounter, switcher, etc.
0
[POWER] Power Indicator Lamp
This lights when power is supplied to the camera.
.
15
[INT/GL, LL] Selector Switch for Synchronizing
System
This switch can set a synchronizing system of the
camera.
INT/GL:
This is set for internal synchronization (INT) or external
synchronization (GL).
LL (Line Lock):
The camera’s vertical synchronization is locked to the
AC 24V power line frequency.
When switching between multiple cameras using a
switcher, selecting this mode and adjusting the vertical
phase can reduce the monitor sync disturbances
occurring when the camera image is switched. (This
cannot be used in regions where the power frequency is
50 Hz.) (INT/GL: At time of factory shipment)
16
[ D U P L E X , S I M P L E X ] S e l e c t o r S w i t c h f o r
Transmission System
If the setting is changed, be absolutely sure to switch
on the power again.
DUPLEX:
This switch sets to DUPLEX when the transmission
between the camera and a remote control unit is in a
duplex system (two-way).
SIMPLEX:
This switch sets to SIMPLEX when the transmission
between the camera and a remote control unit is in a
simplex system (one-way).
(DUPLEX: At time of factory shipment)
17
[RX.TERM-ON/OFF] RX Signal Terminal ON/OFF
Switch
This sets whether or not the signal between RX + and
RX – on the back
20
should be terminated at the value
of 110
Ω
resistance.
ON: terminates.
OFF: does not terminate.
If the system including the camera is the M.DROP
(Multi-drop, RS-485) system, only the camera mounted
at the terminal of control signal cable is set to “ON”
and the other camera is set to “OFF”. In case of the
M.DROP system, it becomes necessary to set the
Machine ID.
If the system including the camera is the P TO P (Point
to Point, RS-422A) system, set this switch of all the
cameras to “ON”.
The item STYLE on the COMMUNICA-TION screen
sets M.DROP or P TO P
(ON: At time of factory shipment)
18
NOT USED
This cannot be used. Do not switch.
TK-C1380E
TK-C1480E
TK-C1480Manual.xprNew 01.10.29 5:27 PM ページ 18
