JVC TK-AM200U - Active Movement Color Dome Camera, Инструкция по эксплуатации

Страница: 17 / 36

17
Positioning
alignment
protrusion
A
Camera
clamp
B
Camera clamping screw
Camera
clamp
Camera
clamping
screw
Ceiling mount
Camera
body
Camera clamping screw
(Slightly loosen)
(Tighten.)
5.
5.
Mount the camera body.
1) Ensure that the camera clamping screw
on the ceiling mount is loosened.
2) Align the ceiling mount’s positioning
alignment protrusion (
A
in the illustra-
tion on the left) with the camera clamp
(
B
in the illustration on the left) position
on the camera body and press the cam-
era body straight against the mount.
CAUTION:
Exercise caution so as not to pinch the
drop prevention wire and the connected
cables.
3) Rotate the camera body clockwise as far
as it will go.
At this point, check that the camera body
clamp is located on the camera clamp-
ing screw on the ceiling mount.
4) Tighten the camera clamping screw.
n
Changing the position of the mounted
camera body
1) Slightly loosen the camera clamping
screw. By turning the camera body
counterclockwise, the position of the
m o u n t e d c a m e ra b o d y c a n b e
changed within a range of approxi-
mately 40 degrees (approximately 20
degrees to the left and right).
Memo:
Loosening the camera clamping screw too
much will cause the camera body to come
off the ceiling mount.
2) After the position for the camera body
is decided, tighten the camera clamp-
ing screw.
CAUTION
Be sure to tighten the camera clamping
screw fully. Otherwise the camera body
may vibrate or drop from the ceiling.
n
To dismount the camera from the ceiling,
perform steps
3. to 5. in reverse order.