JVC Super LoLux TK-C9510E, Инструкция по эксплуатации

Страница: 23 / 324

m
AC 220 V to AC 240 (TK-C9511EG)
When using this camera, install it near the socket so that power
disconnection may be made immediately.
Alarm Signal Connection
For details on the settings, refer to "AUX FUNCTION" (
A
page 52).
The default setting has been set to alarm input. ([IN:ALARM])
m
Alarm Input
Connect the infrared sensor, door sensor, metal sensor, manual switch
sensor and the like.
v
To prevent noise from entering the internal circuit, supply non-voltage
setting signal to the alarm input signal.
v
Do not supply voltage.
v
In the [IN POLARITY] item, you can select whether to set to alarm when
the contact is short (MAKE), or when the contact is open (BREAK).
(
A
page 53)
v
Supply such that the alarm signal stays at a minimum of 200 ms or
more. Otherwise, the alarm signal may not be recognized.
.
AUX(IN)
Z
GND
Use a shielded
cable.
m
Alarm Output
Connect to alarm devices such as alarm, indicator, light or buzzer.
v
The alarm output signal is open collector output and turns ON (or
OFF) during an alarm. (Maximum voltage 16 V, current 30 mA or
below)
v
This terminal has a polarity. Make
sure to connect in such a way that a
higher voltage is output from the +
terminal than from the - terminal.
Otherwise, it will result in damages.
v
In the [OUT POLARITY] item, you
can select whether to set to alarm
when the contact is short (MAKE), or when the contact is open
(BREAK). (
A
page 53)
＊
Internal circuit of the camera
AUX OUT(+)
GND(-)
100
Connection/Installation
E-23