Masterpage:Right0
EN
57
Filename [DVM600US_11Editing.fm]
Page 57
Monday, 25 September 2006 13:54
SYSTEM CONNECTIONS
These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
1
Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
●
For Dolby Digital sound, set
A
DIGITAL AUDIO OUT
B
to
A
DOLBY
DIGITAL/PCM
B
●
For DTS sound, set
A
DIGITAL AUDIO OUT
B
to
A
STREAM/PCM
B
CAUTIONS:
●
This unit has a dynamic range of more than 110 dB with regards
to its Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to
the speakers may damage them.
●
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely
affect the playback picture.
When you can’t switch the audio channel of a bilingual
program
When the unit is connected with a digital audio device using an
optional optical cable and
A
DIGITAL AUDIO OUT
B
is set to
A
DOLBY DIGITAL/PCM
B
, it is not possible to switch the audio
channel of a bilingual program recorded on a DVD-RAM or DVD-R/
RW (VR mode) disc. In this case, perform the following steps using
the remote control to switch
A
DIGITAL AUDIO OUT
B
from
A
DOLBY
DIGITAL/PCM
B
to
A
PCM ONLY
B
.
A
Press
SET UP
to access the Main Menu screen.
B
Press
selection keys
to select
A
DVD VIDEO SET UP
B
, then
press
G
.
C
Press
selection keys
to select
A
AUDIO OUTPUT
B
, then press
G
.
D
Press
selection keys
to select
A
DIGITAL AUDIO OUT
B
, then
press
ENTER
.
E
Press
selection keys
to select
A
PCM ONLY
B
, then press
ENTER
F
Press
SET UP
to complete the setting.
G
Press
AUDIO
to select the desired audio channel.
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
Dolby Digital Decoder or
amplifier with built-in DTS
Coaxial cable
(not supplied)
Rear of unit
Note for connection:
Remove the protection cap from the optical cable.
To [DIGITAL AUDIO
OUTPUT
(COAXIAL)]
To DIGITAL AUDIO input
Optical cable
(not supplied)
To [DIGITAL AUDIO
OUTPUT (OPTICAL)]
DVM600US_00.book Page 57 Monday, September 25, 2006 1:54 PM