JVC RX-DP15B - AV Receiver страница 20 Скачать руководство пользователя

Страница: 20 / 178

Using the RF Rod Antenna and IR Signal
Transmitter

The combination of the RF rod antenna and the IR signal transmitter
allows you to use the multi-room function more conveniently.
The remote control supplied for this receiver can transmit both RF
signal and IR signal at the same time. This receiver catches the RF
signals emitted from the remote control, and converts them into IR
signals, then transmits the converted signals to the remote sensor on
the other components through the IR signal transmitter.
This means that you can control not only this receiver but also other
components from Zone 2.

Setting Up the RF Rod Antenna

The remote control supplied for this receiver can transmit RF (Radio
Frequency) signals as well as IR (infrared) signals. The RF rod
antenna can receive the RF signals emitted from the remote control.
So, with the RF rod antenna connected, you can operate the receiver
at a distance of up to 15 m (50 feet) using RF signals sent from this
receiver (more than twice as far as when using IR signals).
Moreover, RF signals can go through walls and other objects in the
house so you need not aim at the receiver directly.
However, if the antenna cannot receive signals stably, you cannot
operate the receiver correctly.
• Without the RF rod antenna connected, you can operate the

receiver with the remote control, aiming the remote control
directly at the remote sensor on the receiver.

To set up the RF rod antenna

1. Insert the RF rod antenna onto the RF REMOTE

ANTENNA terminal.

2. Rotate the fixing nut to attach the RF rod

antenna firmly.

Notes:

• The signal-reachable distance may differ depending on the

operating conditions and circumstances. To improve transmitting
conditions, change the distance to the receiver and the direction to
transmit while operating the remote control.

• To avoid a failure in the reception from the remote control, keep the

connecting cables and the IR signal transmitter’s cable away from
the RF rod antenna.

• If your neighbour uses the same or similar RF remote control

system, the receiver may happen to receive the RF signals sent
from such an RF remote control system, which could cause your
receiver to be operated unintentionally. If this happens, set the
BAND 1/2 selectors (both on the rear and in the remote control) to
another band (either BAND 1 or BAND 2).

If the problem still persists, stop using the RF rod antenna and the
remote control, and consult your JVC dealer or the nearest JVC
Service Center.

Setting Up the IR Signal Transmitter

The IR signal transmitter can retransmit the IR signals.
It allows you to use the AV COMPU LINK remote control system,
and to operate other manufacturers’ components

without aiming the

remote control directly at the remote sensor on the target
components. In addition, the IR signal transmitter reduces the
possibility of malfunction.
• The IR signal transmitter may not operate the target components

depending on the operating conditions and circumstances—
including the aiming angle and direction of the IR signal
transmitter at the remote sensors of the target components. If
this occurs, changing its aiming angle and direction at the
remote sensors may solve the problem.

To set up the IR signal transmitter

1. Find a place where you can attach the IR signal

transmitter.

• Place the transmitter where the signal can reach the remote

sensor of the target components in a direct line of sight.

• If the cord length of the IR signal transmitter is not long

enough, use an extension cord (not supplied).

2. Attach the double-sided adhesive tape (supplied)

to the IR signal transmitter.

On the main unit’s rear

1 2

In remote control
(Inside the battery compartment)