background image

CD PORTABLE SYSTEM

RC-EX16B/RC-EX16A

INSTRUCTIONS

LVT1374-003A [B]

ENGLISH

Thank you for purchasing this JVC product.

Please read these instructions carefully before starting operation to be sure to
obtain optimum performance and a longer service life from the unit.

SAFETY PRECAUTIONS

IMPORTANT for the U.K.

DO NOT

 cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in

your home or the cable is too short to reach a power point, then obtain an appropriate safety approved
extension lead or consult your dealer.

BE SURE

 to replace the fuse only with an identical approved type, as originally fitted.

If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to
avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not supplied fitted with a mains plug then follow the instructions given below:

IMPORTANT

.

DO NOT

  make any connection to the terminal which is marked with the letter E or by the safety earth

symbol or coloured green or green-and-yellow.

The wires in the mains lead on this product are coloured in accordance with the following code:

Blue :        Neutral
Brown :     Live

As these colours may not correspond with the coloured markings identifying the terminals in your plug
proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or
coloured red.

IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.

Caution –– 

 OFF switch!

Disconnect the mains plug to shut the power off completely. The switch in any position does not disconnect
the mains line. The power cannot be remote controlled.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:
1. Do not remove screws, covers or cabinet.
2. Do not expose this appliance to rain or moisture.

IMPORTANT FOR LASER PRODUCTS

1. CLASS 1 LASER PRODUCT
2.

CAUTION:

 Do not open the top cover. There are no user serviceable parts inside the

unit; leave all servicing to qualified service personnel.

3.

CAUTION:

  Visible and invisible laser radiation when open and interlock failed or

defeated. Avoid direct exposure to beam.

4. REPRODUCTION OF LABEL: CAUTION LABEL, PLACED INSIDE THE UNIT.

CAUTION -

INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCKS
DEFEATED. AVOID EXPOSURE TO BEAM.

VORSICHT !

UNSICHTBARE LASERSTRAHLUNG TRITT AUS, WENN DECKEL
GEÖFFNET UND WENN SICHERHEITSVERRIEGELUNG
ÜBERBRÜCKT IST. NICHT DEM STRAHL AUSSETZEN!

VARNING -

OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD OCH
SPÄRR ÄR URKOPPLAD STRÅLEN ÄR FARLIG.

ADVARSEL -

USYNLIG LASERSTRÅLING VED ÅBNING NÅR
SIKKERHEDSAFBRYDERE ER UDE AF FUNKTION. UNDGÅ
UDSÆTTELSE FOR STRÅLING.

Caution: Proper Ventilation

To avoid risk of electric shock and fire, and to prevent damage, locate
the apparatus as follows:
1 Front:

No obstructions and open spacing.

2 Sides/ Top/ Back:

No obstructions should be placed in the areas shown in the
illustration on the right.

3 Bottom:

Place on the level surface. Maintain an adequate air path for
ventilation by placing on a stand with a height of 10 cm or more.

EN

© 2005 Victor Company of Japan, Limited

0205NSMBICORI

GETTING STARTED

POWERING UP

This CD portable system operates on battery or AC power.

BATTERY POWER

Insert six batteries R20 (SUM-1)/D (13D) (not supplied) and you
can take your system just about anywhere. Open the battery
compartment door on the back of the unit by pressing down the
two tabs and pulling out the cover. Insert batteries as marked on
the back.

Important Battery Information

• If you are not going to use your system for a month or more, be

sure to remove batteries because they can leak and cause
damage.

• Dispose of batteries in the proper manner, according to federal,

state, and local regulations.

• Discard leaky batteries immediately. Leaking batteries can

cause skin burns or other personal injury.

AC POWER

Plug the power supply cord into the 

Ó

 AC IN jack on the back of the unit, and into an AC power outlet.

CAUTIONS:
1. ONLY USE JVC POWER CORD  PROVIDED WITH THIS UNIT TO AVOID MALFUNCTION OR DAMAGE

TO THE UNIT. REMOVE BATTERIES WHEN USING THE POWER CORD.

2. BE SURE TO UNPLUG THE POWER CORD FROM THE OUTLET WHEN GOING OUT OR WHEN THE

UNIT IS NOT IN USE FOR AN EXTENDED PERIOD OF TIME.

USING HEADPHONES

Connect commercially available headphones to the PHONES jack on the rear of the main unit. While the head-
phones are connected, the speakers do not produce any sound. Before connecting the headphones, make sure
to turn down the sound volume.

ANTENNAS

The AM antenna is built in, so adjusting the position of the unit may help AM reception. The FM telescopic
antenna on the back of the unit can be extended and rotated for better FM reception.

GENERAL CONTROLS

FUNCTION switch

 – Move the switch to select which part of this system you want to select – TUNER, TAPE or

CD.

VOLUME

 – Turn the volume knob to increase or decrease the volume to desired level.

HBS

 – Press so that the HBS indicator lights. You can enjoy powerful bass sound with the Hyper-Bass Sound

effect.

POWER OFF

 – Move FUNCTION to 

OFF/TAPE with no cassette button pressed, to turn the unit off.

USING THE RADIO

TUNING IN RADIO STATIONS

Move FUNCTION to TUNER to turn the radio on.
• Set BAND to AM or FM.
• Tune in desired station by turning the TUNING knob.
• To turn off the radio, move FUNCTION to 

OFF/TAPE.

BEAT CUT/FM MODE SWITCH

When recording an AM broadcast

When recording an AM broadcast, beats may occur. If this happens, set the switch
to “1” or “2.”

Changing the FM reception mode

When an FM stereo broadcast is hard to receive or noisy, set the switch to “MONO.”
Reception improves.
To restore the stereo effect, switch to “STEREO.”

USING THE TAPE

PAUSE

   – Press to interrupt tape play or record mode. Press a second time to resume tape play or tape record

mode.

STOP/EJECT

 

 – Press to stop the current tape activity, or to open the cassette compartment door when no

buttons are active.

FF

 

 – In stop mode, press to advance the tape toward the end. (When the tape reaches the end, press

STOP/EJECT 

 to release the depressed button.)

REW

 

 – In stop mode, press to rewind the tape toward the beginning. (When the tape reaches the end, press

STOP/EJECT 

 to release the depressed button.)

PLAY

 

 – Press to play cassettes.

REC

 

  – Press to record from the radio or CD player.

PLAYING A CASSETTE TAPE

1. Move FUNCTION to 

OFF/TAPE.

2. Press STOP/EJECT 

 to open the cassette compartment door.

3. Insert a cassette tape into the compartment with the exposed part of the tape facing up and the side you want

to play facing toward you.

4. Close the door securely.
5. Press REW 

 or FF 

 to move the tape to the desired starting point.

6. Press PLAY 

 to begin playing the tape. The cassette tape plays until it reaches the end of the side, then it

automatically stops.

RECORDING ON CASSETTE TAPES

You can record from the radio or the CD player.
For best recording, use normal bias tape.

It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without
the consent of the owner of copyright in the sound or video recording, broadcast or cable program
and in any literary, dramatic, musical, or artistic work embodied therein.

ERASE PROTECTION

When you record new material, the cassette deck records over what-
ever is on a tape. To protect a tape from accidental erasure, break
off one or both plastic tabs (one for each tape side) on the top of the
cassette tape. If you decide later to record on the tape, seal the
hole with a piece of cellophane tape.

WARNING

A little bit of slack in your tape can cause scratches on the tape, or worse yet, the tape
could break. If you notice some slack in the tape, use a pencil to tighten it up before you
insert it in the tape deck.

TIP

The use of tapes longer than 120 minutes is not recommended, since characteristic deterioration may occur and
these tapes easily jam in the pinch-roller and the capstan.

FM telescopic 
antenna

BEAT CUT/FM 
MODE switch

AC IN jack

Battery compartment

PHONES jack

BEAT CUT

FM MODE

1

2

STEREO

MONO

Turn Over

15 cm

15 cm

15 cm

10 cm

15 cm

15 cm

15 cm

10 cm

Front view

Side view

Содержание RC-EX16A













Отзывы: