17
Operation
Selecting an input source
The projector can be connected to multiple equipment at the same time. However, it only
displays one full screen at a time. When starting up, the projector automatically searches for the
available signals.
If you want the projector to always automatically search for the signals:
• Go to the
SOURCE
menu, and then enable
Quick Auto Search.
To select the video source:
1. Press
SOURCE
to display the source selection bar.
2. Press
/
until your desired signal is selected and press
ENTER
.
Once detected, the selected source information displays on the screen for seconds. If there
are multiple pieces of equipment connected to the projector, repeat steps 1-2 to search for
another signal.
Refer to
for the native display resolution of this projector. For best display
picture results, you should select and use an input signal which outputs at this resolution. Any other
resolutions will be scaled by the projector depending upon the Aspect Ratio setting, which may cause
some image distortion or loss of picture clarity. See
for details.
Содержание LX-FH50
Страница 1: ...USER MANUAL DLP PROJECTOR LX FH50 ...
