15
Customising your TV
Select
Exit
MENU
Navigate
PCM
Digital Audio Output
Banner Duration
Auto
Receiver Upgrade
No CI Module
2 sec
Common Interface
Antenna Power
Off
Setup
14:00 05/05/2007
Output the digital signal from the DIGITAL AUDIO OUT terminal.
:
The Linear PCM signal is output
The Dolby digital signal is output when the Dolby Digital signal is received
z
Please read ““Dolby Digital” output from the DIGITAL AUDIO OUT terminal” (P. 22) before setting.
Select the display time for channel information
(2 sec / 5 sec / 8 sec)
The TV will automatically search for new tuner software and run the reception test (for digital
channels) at midnight (3 AM) on a daily basis. You can select the desired operation with this
setting.
z
The Receiver Upgrade function works only when the TV is off (standby).
z
If new software is available, the TV will automatically download and upgrade the tuner software.
z
If the TV detects channels that became receivable or if the TV was not able to receive a certain channel,
a message about updating the PR List will be displayed when the TV is turned on.
g
“Updating the PR List” (P. 21)
:
The search for new software and the reception test will operate at midnight. In
addition, the TV will start searching for new software whenever the TV is
turned off. Normally set to “Auto”.
:
Only the search for new software will operate at midnight. The reception test
will not be run. In addition, you can start searching for new software whenever
you want.
To start searching, select “Manual” and press “OK” button.
Select “Search for new” and press “OK” button. Then, follow the instructions
on the screen.
Upgrade the software automatically when the TV is turned off.
Software Version
OK
Search for new
0.44.05
LT-42DP8BJ_Digital.book Page 15 Wednesday, July 4, 2007 2:47 PM