JVC LT-26B60BU, Инструкция по эксплуатации

Страница: 22 / 32

ENGLISH - 21 -
Picture Mode
Picture mode OSD is displayed when BLUE
button is pressed. Picture mode can be
changed to standard, soft, and bright.
Sleep Timer
Sleep Timer mode OSD is displayed when
YELLOW button is pressed.
The Sleep Timer is used to turn the TV off after
a defined period of time after selecting this
item. The timer can be programmed between
Off and 120 minutes in steps of 10 minutes.
(Off, 010, 020, 030, 040, ... , 120)
If sleep timer is activated, at the end of the
selected time, the TV goes automatically to
stand-by mode.
Mute Indicator
It is placed in the upper middle of the screen
when enabled, and it stays there until it is dis-
abled.
To cancel mute, there are two alternatives; the
first one is by pressing the " " button, this
volume is set to the preceding value, and the
second one is increasing or decreasing the
volume level.
No-Signal Detection (TV mode)
If no valid signal detected, it takes 5 minutes
to switch to the Stand-By mode unless any
signal detected or any Remote Control com-
mand is accessed.
After a Remote Control command (if No-Sig-
nal Timer is active) the timer stops and if no
signal detected again the timer is initialized to
5 minutes and starts 3 seconds later again to
count down.
It is not valid in EXT modes.
No-Signal and Out Of Range
Detection (PC mode)
In PC Mode, as no menu is displayed, in case
that there is no PC input to the TV, it is dis-
played an OSD message:
No input signal detected
then the TV will turn to be in PC standby mode.
In PC standby mode, the green lamp blinks.
Press “ AV ” button, digit buttons or “ ” /
“ ” buttons to exit standby mode.
In PC Mode, if the resolution and the vertical
frequency is not supported by the concept, it is
displayed an OSD message:
Signal out of range
Volume Bar
It is displayed in the lower middle of the screen.
When a volume command is received (press-
ing “
+” or “ -” by Remote Control or
Control panel on the right side of the TV) and
no menu is active, it stays on the screen for 3
seconds, after the last volume command or
until another command is received in between.
EXT Modes
By pressing the “ AV ” button you can switch
your TV to EXT modes (except being in Tele-
text). Pressing this button consecutively will
switch the TV in one of the optional EXT
modes: EXT-1, EXT-2, EXT-2 S, EXT-3, EXT-4,
EXT-4 S and PC .
In order to quit the EXT mode press any digit
buttons or “
” or “ ”.