JVC KY-PZ100BE, Инструкция по эксплуатации

Страница: 103 / 116

List of Live Streaming Error Displays
The following error messages are displayed when the live streaming setting is incorrect, or when the
connection is lost during live streaming.
Error message Status Action
Invalid Address
0
The IP address format is
incorrect.
0
The domain name cannot be
converted into the IP address.
0
Enter the IP address, host name
or URL of the destination
correctly.
(
A
P97 [Setting Distribution] )
Multicast Is Not Supported An IP multicast address was set. Use an IP address that is not a
multicast address.
Cannot Connect to Receiver Establishment of connection with
TCP failed.
0
Ensure that the recipient’s
device is set to TCP.
0
Set Type to “MPEG2-TS/UDP”.
(
A
P97 [Setting Distribution] )
TCP Disconnected TCP connection is lost. Check to ensure that there is no
abnormality in the decoder, or
network connection device and
cables, followed by establishing the
connection again.
Not Enough Bandwidth
0
The communication bandwidth
is narrower than the average bit
rate.
0 The network bandwidth is
insufficient, and packets are
discarded.
0
Lower the resolution/picture
quality of the video to be
distributed.
0 Consider switching to the use of
a stable network, such as wired
LAN.
Connection Timeout Timeout for connection via ZIXI. Set [Destination Address] and
[Destination Port] correctly.
(
A
P97 [Setting Distribution] )
Authorization Failed Authentication of connection via
ZIXI failed.
Set [Stream ID] and [Password]
correctly.
(
A
P97 [Setting Distribution] )
Connection Error Connection via “ZIXI” or “RTMP”
failed.
0
Check whether a different
camera with an identical stream
ID is connected.
0
Set [Destination URL] and
[Stream Key] correctly.
(
A
P61 [ Destination URL ] )
(
A
P61 [ Stream Key ] )
Disconnected “ZIXI” or “RTMP” connection is lost. Check whether there is abnormality
with the network connection device,
cables, etc., and try to re-establish
the connection.
Streaming is unable to reach
the destination.
0
The IP address format is
incorrect.
0
The domain name cannot be
converted into the IP address.
0
Streaming is unable to reach
from the terminal specified in
[Interface].
0
The terminal specified in
[Interface] is not consistent with
the terminal in [Default
Gateway] when streaming on a
non-local network.
0
Enter the IP address, host name
or URL of the destination
correctly.
0
Check and adjust the interface
settings.
0
Make sure that the interface
settings are consistent with
those of the default gateway.
Error Messages and Actions
103
Others