JVC GY-HM790U, Инструкция по эксплуатации

Страница: 131 / 144

127
䡵
Phase Items to Synchronize
The phase items to be synchronized may vary depending on
the input synchronizing signal and output video signal. (See
table below)
Adjusting the H Phase
1
Select [Genlock Adjust] in the [Others] menu. ( A Page 96)
2
Select the phase item to adjust in [Genlock Adjust].
3
Select a value using the cross-shaped button ( JK ).
The H phase of the camera recorder’s video signals is
adjusted with respect to the external synchronizing signal
input to the [GENLOCK INPUT] terminal.
You can alter the setting value for [Analog HD H Phase], [SD-
SDI H Phase], and [HD-SDI H Phase] in increments of 10 by
pressing down the cross-shaped button (
JK ) for 2 seconds
or longer.
Memo :
●
Adjustment cannot be performed when recording or
playback is in progress.
●
The video image may be disrupted momentarily during
adjustment. This is not a malfunction.
Terminal
Output Video
Signal
Input Sync Signal
BB
Tri-sync
720p 1080i
VIDEO Composite H, V, F V V, F
Y/PB/PR
SD Component H, V, F V V, F
HD Component
720p
V H, V V
HD Component
1080i
V, F V H, V, F
HD/SD-SDI
SD-SDI H, V, F V V, F
HD-SDI 720p V H, V V
HD-SDI 1080i V, F V H, V, F
H : Horizontal phase F : Field phase
V : Vertical phase
Analog SD H Phase : For adjusting the H phase of SD analog
signal.
Analog HD H Phase : For adjusting the H phase of HD analog
signal.
SD-SDI H Phase :
For adjusting the H phase of SD-SDI
signal.
HD-SDI H Phase
:
For adjusting the H phase of HD-SDI
signal.