JVC GY-HM100, Инструкция по эксплуатации

Страница: 18 / 76

18
Preparation s
Adju s ting the Grip Belt
Open the pad and adjust the position of the grip b elt accordingly.
Caution :
●
If the grip is loose, the camcorder may fall off resulting in
injuries or malfunction.
●
Parents should take extra care when your child is using the
camcorder.
Setting up the Remote Control
The remote control comes supplied with b atteries when you
purchase this product.
To start using, pull out the insulation sheet.
Memo :
●
To use the remote control, set [REMOTE] in the [CAMERA
S ETTING S ] menu to [ON].
●
Point the front end of the remote control toward the sensor.
Use the remote control within a distance of 5 meters from
the camcorder. The camcorder may not respond to the
remote control operations at some angles.
䡵
Replacing batterie s
1 .
Pre ss the lock tab, and pull out the battery holder.
2 .
Replace the button battery (CR2025).
Attaching an External Microphone
You can attach a microphone to the microphone holder.
The supplied microphone is a phantom microphone.
1 .
Turn the knob on the microphone holder
anticlockwi s e to loo s en it and open the microphone
holder.
2 .
Place the microphone in the microphone holder.
3 .
Turn the knob on the microphone holder clockwi s e
to s ecure the microphone.
4 .
Connect the microphone to the INPUT1/INPUT2
audio input terminal, or the MIC terminal according to
the type of microphone cable terminal you are u
s ing.
INPUT1/INPUT2 Terminal: XLR Terminal
MIC Terminal
: Mini-jack Terminal (stereo)
5 .
Attach the microphone cable to the clamp.
6 .
Specify the audio input s etting s correctly.
(
A
Page 40)
Memo :
●
When the audio unit ca b le is connected to the AUDIO IN
terminal of the camcorder, the MIC terminal is disa b led.
Attaching the Tripod
To prevent the camcorder from falling off, which may result in
injuries or damages, read the instruction manual of the tripod
to
b e used and make sure that it is securely attached.
(
A
Page 12)
Caution :
●
Use the tripod on a sta b le surface.
Setting s and Adju s tment s
Before U s e
AWB
Remote Control S ensor
Insulation S heet
Lock Ta b
Button Battery
AUDIO IN
OPEN
2. Microphone
Microphone Holder
5. Clamp
4. INPUT1/
INPUT2 Terminals
1. 3 . Kno b
AUDIO IN
Terminal
4. MIC Terminal
M9H7_EN_001D.book Page 18 Thursday, August 26, 2010 11:51 AM