JVC GR-SXM250US, Руководство по обслуживанию

Страница: 15 / 75

(No.86721)1-15
2.6 EMERGENCY DISPLAY
Whenever some abnormal signal is input to the mechacon CPU,
an error number (E01, as an example) is displayed in the elec-
tronic view finder. In every error status, such the message as
shown below alternately appear over and over.
• In an emergency mode, all operations except turning on/off the
POWER switch are ineffectual.
(NTSC)
2.7 AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when “DEMO MODE” is
set to “ON” (factory-preset).
(1) Available when the Power Switch is set to “A” or “M” while
pressing down the Lock Button located on the switch.
(2) Performing any operation during the demonstration stops
the demonstration temporarily. If no operation is performed
for more than 1 minute after that, the demonstration will
resume.
(3) “DEMO MODE” remains “ON” even if the camcorder power
is turned off.
(4) To cancel Automatic Demonstration, set the Power Switch
to “M” and press the MENU Wheel in while the demo is in
progress. This takes you directly to the demo mode’s Set-
ting Menu (so you will not have to go through the main
Menu Screen). Rotate the MENU Wheel to select “OFF”
and press it.
NOTE:
• When a tape whose Erase Protection tab is in the position
that allows recording is loaded in the
camcorder, demonstration is not available.
• If you do not detach the Lens Cap, you cannot see the actual
changes of the Automatic Demonstration activated on the
LCD monitor or viewfinder.
* Applicable models only.
Fig.2-7-1
Example (in case of the error number E01):
E01
UNIT IN
SAFEGUARD MODE
E01
REMOVE AND
REATTACH BATTERY
E. VF Symptom Mode when observed
E07 Short circuit of capstan MDA Power ON
E06 CAPSTAN FG input absent CAPSTAN rotation
E04 DRUM FG input absent DRUM rotation
E03 SUPPLY REEL FG input absent REC, PLAY, SEARCH, FF/REW
E02 Mode control motor rotates for more than 6.0 sec UNLOADING without shift to next
mode.
UNLOADING
E01 Mode control motor rotates for more than 6.0 sec LOADING without shift to next mode. LOADING
E00 Overtime the programming transaction REC, PLAY
MENU Wheel
Power Switch
Lock Button