EN
15
GETTING STARTED
MasterPage: Start_Right
Using The Battery Pack
Perform steps
Maximum continuous recording time
* Provided
NOTES:
●
Recording time is reduced significantly under the
following conditions:
•
Zoom or Record-Standby mode is engaged
repeatedly.
•
The LCD monitor is used repeatedly.
•
The playback mode is engaged repeatedly.
•
The LED Light is used.
●
Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned shooting time.
ATTENTION:
Before detaching the power source, make sure that
the camcorder’s power is turned off. Failure to do so
can result in a camcorder malfunction.
Data Battery System
You can check the remaining battery power and
the recordable time.
1)
Make sure the battery is attached and the
Power Switch is set to “OFF”.
2)
Open the LCD monitor fully.
3)
Press
DATA
, and the battery status screen
appears.
●
It is displayed for 3 seconds if the button is
pressed and released quickly, and for 15
seconds if the button is pressed and hold for
several seconds.
●
If “COMMUNICATION ERROR” appears
instead of the battery status even though you
tried to press
DATA
several times, there may
be a problem on the battery. In such a case,
consult your nearest JVC dealer.
Using AC Power
Perform steps
NOTE:
The provided AC Adapter features automatic
voltage selection in the AC range from 110 V to
240 V.
About Batteries
DANGER!
Do not attempt to take the batteries
apart, or expose them to flame or excessive
heat, as it may cause a fire or explosion.
WARNING!
Do not allow the battery or its
terminals to come in contact with metals, as this
can result in a short circuit and possibly start a
fire.
To resume the original function of the
accurate battery power indication
If the battery power indication differs from the
actual operating time, fully charge the battery, and
then run it down. However this function may not
turn back if the battery was used for a long period
of time under extremely high/low temperature
condition or charged too many times.
To turn on the camcorder, set the Power Switch
to any operation mode except “OFF” while
pressing down the Lock Button located on the
switch.
Choose the appropriate operation mode
according to your preference using the Power
Switch and
VIDEO/MEMORY
Switch.
Battery pack
LCD monitor
on
Viewfinder on
BN-VF707U*
1 hr. 30 min.
1 hr. 40 min.
BN-VF714U
3 hrs. 5 min.
3 hrs. 25 min.
BN-VF733U
7 hrs. 20 min.
8 hrs.
Operation Mode
Power Switch Position
REC:
●
Allows you to perform recording on the tape.
●
Allows you to set various recording functions
using the Menus. (
OFF
:
Allows you to switch off the camcorder.
PLAY:
●
Allows you to play back a recording on the
tape.
●
Allows you to display a still image stored in
the memory card or to transfer a still image
stored in the memory card to a PC.
●
Allows you to set various playback functions
using the Menus. (
POWER/
CHARGE
lamp
Lock Button
MENU
AUTO
VIDEO/
MEMORY
Power
Switch
CONTINUED ON NEXT PAGE
GR-D650AA.book Page 15 Tuesday, May 30, 2006 9:31 AM
