EN
13
GETTING STARTED
MasterPage: Start_Right
NOTES:
●
In order to maintain optimum performance of the
camcorder, provided cables may be equipped with
one or more core filter. If a cable has only one core
filter, the end that is closest to the filter should be
connected to the camcorder.
●
Make sure to use the provided cables for
connections. Do not use any other cables.
How To Attach The Lens Cap
To protect the lens, attach
the provided lens cap to the
camcorder as shown in the
illustration.
NOTE:
To confirm the lens cap is on
correctly make sure the cap is
flush to the camcorder.
How To Attach The Shoulder Strap
Follow the illustration.
1
Thread the strap through the eyelet.
2
Fold it back and thread it through the strap
guide and the buckle.
●
To adjust the length of the strap, loosen and then
tighten the strap in the buckle.
3
Slide the strap guide fully towards the eyelet.
How To Attach The Core Filter
Attach the core filters to the cables. The core
filter reduces interference.
1
Release the stoppers on both ends of the
core filter.
2
Run the cable through the core filter, leaving
approx. 3 cm of cable between the cable plug
and the core filter.
Wind the cable once around the outside of the
core filter as shown in the illustration.
3
Close the core filter until it clicks shut.
NOTES:
●
Take care not to damage the cable.
●
When connecting a cable, attach the end with the
core filter to the camcorder.
Place here during
shooting.
2
2
1
3
Strap guide
Buckle
Eyelet
Stopper
3 cm
Wind once.
Core filter
GR-D650E-640E.book Page 13 Tuesday, May 30, 2006 11:31 AM
