5
Adjust the focus
You can adjust the focus using the “Focus” item of the “Lens” menu.
To move the focus point closer:
Press the “+” (Near) end of “Focus”
To move the focus point away:
Press the “-” (Far) end of “Focus”
MEMO
0
The focus changes each time you click on the inner buttons (
a
/
b
). (Fine control)
The outer buttons (
d
/
c
) change the focus when they are depressed. (Coarse control)
6
Select a screen mode for projection
You can specify the screen mode using “Display Mode” of the “Setting” menu. (P. 38)
.
Setting
Convergence
Lens
Option
Logout
host PJ-1
user: root
Input Level
Main
Image
0-255(PC)
Display Mode
16-235
1
1
3
3
1
2
4
License
MEMO
0
The projected image varies according to the mode of connection. (P. 19, 21)
7
Click the “OFF” button under the “Power” item of the “Main” menu to end the projection
0
The projector switches to the cool down mode, and the [STANDBY/ON] indicator appears blinking in red.
0
A gray image will be displayed for a maximum duration of 2 minutes during the ending process only after several
hours of image projection. Thereafter, the LD block starts to cool down.
0
After exiting the cool down mode, the projector switches automatically to the standby mode, and the
[STANDBY/ON] indicator lights up in red.
0
You can also turn off the power by pressing the [OPERATE
Z
] button on the projector unit for more than one
second.
Cool down mode
Cool down mode is a function that cools down the LD block for about 10 seconds after projection ends (ending
process).
0
When the projector is in the cool down mode, the [STANDBY/ON] indicator appears blinking in red.
0
Do not shut down the main power supply or unplug the power cord when in the cool down mode. Also, do
not block the air inlets and vent holes. Doing so may shorten the lamp life and cause a malfunction.
31
Operation
and
Settings
