Juplink EC3-1200, Руководство пользователя

Страница: 25 / 28

product label) of the repeater, you can get the IP address of repeater assigned by the
router.
•
Open a browser, enter the IP address in the address bar, and then you can access
the Web page of the repeater.
Method 3: (recommended)
•
Download device firmware file v1.0.2 from juplink.com and conduct firmware
upgrade.
•
After reset, try logging in to domain name: router.juplink.com
Q5: Why can l find someone else's Wi-Fi network, but not mine?
A5:
•
Please check if your mobile device can be connected wirelessly to the repeater in
the same place, as the signal in this place may be poor.
•
Check if the encryption mode of the uplink router is WEP. Only no encryption,
WPA, WPA2 and mixed mode are supported by this repeater.
•
Check on your mobile device to see if the uplink wireless network is hidden.
Q6: Why does it always prompt for failure during extension?
A6:
•
Check if the wireless signal indicator is green or off. Off indicates extension
failure.
•
If you can't find the uplink wireless network during extension, please try the
following:
①
Set the SSID of the router and that of the repeater to combinations of numerals
and letters.
②
Move the repeater closer to the router ( within 1ft is recommended );
③
Ensure that the encryption mode of the uplink wireless network is not WEP. Only
no encryption, WPA-PSK, WPA2-PSK or mixed mode of the above is supported by the
repeater.
④
Ensure that the uplink wireless network is not turned off or hidden.
⑤
Log in to the Web page of the router to check if any restriction is made, such as
MAC filter, blacklist, etc.
⑥
Ensure that the correct password of the uplink router is entered during
extension.
⑦
Modify the wireless network name and password of the uplink router, and reset
the repeater.
Q7: How do I know if the extension is successful?
A7:
①
Check if there is the default SSID. If yes, the extension fails.
②
Check the status of the wireless signal indicator. On or flashing indicates
successful extension, while off indicates extension failure.
③
Log in to the Web page of the repeater to see if it is in the extended state.
•
If you are sure that the extension is successful, keep the antennas upwards and in
parallel with the antennas of the router. If not, please adjust their angle.
•
Try putting the repeater and router closer, and check if the indicator becomes