![Jupiter Avionics JA95-N02 Скачать руководство пользователя страница 23](http://html.mh-extra.com/html/jupiter-avionics/ja95-n02/ja95-n02_installation-and-operating-manual_2033796023.webp)
JA95-N02 Audio Controller - Six Transceiver - NVG
Installation and Operating Manual
Rev B
Page 19
(5)
Multi-function (Transmit/ICS) Switch
This is a green two-position centre-off momentary toggle switch.
When in the default XMIT/ICS configuration, this switch acts as
the pilot’s ‘Press-to-talk’ (PTT) button. The unit will transmit on
the selected transceiver when the switch is held in the ‘up’
position, and when held in the ‘down’ position, it will transmit on
the intercom.
See
below for Multi-function Switch operation.
Note
: At installation, this switch may be configured to operate in default or alternative mode. Check with your
installing agency for confirmation of the operation of this switch. The legends are interchangeable to allow
customization.
(6)
Music/Configuration Connector (
♫
/io)
This is a music input that is compatible with most music players.
It accepts a 3 pole 3.5mm stereo plug with a slim diameter
connector housing.
(This connector is also used during installation to change
configuration settings.)
♫
CAUTION
:
If an unapproved connector or cable is used, damage to the unit or to any attached device may
occur. If in doubt, contact JAC for a list of approved cables, music sources and devices.
(7)
Transmit Annunciator - TX
This is a deadfront annunciator that will illuminate when
the JA95 is transmitting.
The default legend is ‘TX’, but it is interchangeable to
allow customization.
(8)
Transmit Selector
This is a rotary six-position control that is
used to select transmission via one of the
six transceivers.
Each of the transmit selector positions is
linked by a white line to the corresponding
transmit select annunciator, transceiver
switch and legend.
The appropriate annunciator will light green
to show which transceiver is selected for
transmit - ‘FM3’ in this example.