JUNO JKU6436, Руководство по эксплуатации

Страница: 8 / 17

23
t
The freezer compartment, however, will become
progressively covered with frost. This should be
removed with the special plastic scraper provided,
whenever the thickness of the frost exceeds 4 mm.
During this operation it is not necessary to switch off
the power supply or to remove the foodstuffs.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
as follows:
1. pull out the plug from the wall socket or turn the
thermostat knob to the «O» setting;
2. remove any stored food, wrap it in several layers of
newspaper and put it in a cool place;
3. leave the door open, place a basin on the top shelf
of the refrigerator compartment, under the drain
hole, remove the plug as shown in the figure;
4. when defrosting is completed, dry the interior
thoroughly and refit the plug.
5. Keep the scraper for future use.
6. Turn the thermostat knob back to the required
setting or replace the plug in the power socket.
7. After two or three hours, reload the previously
removed food into the compartment.
Important
Never use sharp metal tools to scrape off
frost from the evaporator as you could
damage it.
Do not use a mechanical device or any
artificial means to speed up the thawing
process other than those recommended by
the manufacturer.
A temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
PR151
Periodic cleaning
Never use metal objects for clearing your appliance as
it may get damaged. Clean the inside with warm water
and bicarbonate of soda. Rinse and dry thoroughly.
The appliance is equipped with a ventilation grid. Keep
clean to guarantee good ventilation and good working
order of the appliance.
An accumulation of dust will affect the performance of
the appliance and cause excessive electricity
consumption.
The structure of the appliance permits cleaning of the
rear zone close to the wall, using a vacuum cleaner.
1. Remove the plinth (1), then the ventilation grid (2);
2. Carefully pull the air deflector out (3), checking that
there is no water left from the defrosting.
S.I.013
3 2 1