Juniper SRX5400, Руководство по оборудованию

Страница: 326 / 394

1.
Switch off the dedicated facility circuit breaker for the power supply, and remove the
power cord from the AC power source. Follow the ESD and disconnection instructions
for your site.
2.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
3.
Move the AC switch next to the appliance inlet on the power supply to the off
position (
O ).
4.
Unscrew the captive screws on the bottom edge of the power supply.
5.
Remove the power cord from the power supply.
6.
Pull the power supply straight out of the chassis.
Figure 121: Removing an AC Power Supply
Installing an SRX5400 Services Gateway AC Power Supply
To install an AC power supply (see Figure 72 on page 158 ):
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2.
Move the AC switch next to the appliance inlet on the power supply to the off
position (
O
).
3.
Using both hands, slide the power supply straight into the chassis until the power
supply is fully seated in the chassis slot. The power supply faceplate should be flush
with any adjacent power supply faceplate (see
Figure 72 on page 158 ).
4.
Tighten both captive screws at the bottom of the power supply.
5.
Attach the power cord to the power supply.
6.
Route the power cord along the cable restraint toward the left or right corner of the
chassis. If needed to hold the power cord in place, thread plastic cable ties, which you
must provide, through the openings on the cable restraint.
Copyright © 2017, Juniper Networks, Inc. 300
SRX5400 Services Gateway Hardware Guide