Juniper SRX300 Series, Руководство пользователя, Страница: 90 / 128

3.
Add a security zone to the interface:
a.
Select
Configure>Security>Zones/Screens
.
b.
Add or select a security zone other than Null; for example,
Trust
. Assign the interface
to the zone.
c.
For Host Inbound Traffic-Zone, set the following:
•
System Services=
Allow All
•
Protocols=
Allow All
d.
Click
OK
to save changes, and select
Commit>Commit
to apply the configuration
and other pending changes (if any).
4.
To use the port on the Mini-PIM, you must also set security policies. Select the following
settings:
a.
Select
Configure>Security>Security Policy
.
b.
Select Global Options > Policy Options .
c.
Set Policy Action: Default Policy Action=
Permit-All
.
d.
Click OK to save changes, and select Commit>Commit to apply the configuration
and other pending changes (if any).
Using the CLI
To perform basic configuration for the 1-Port Serial Mini-PIM and to configure network
interfaces for the services gateway with the CLI:
1.
Verify that the serial interface is installed on the device:
show chassis hardware
2.
Verify the status of the interface:
show interfaces terse
3.
Assign the port an IP address:
set interfaces se-1/0/0 unit 0 family inet address interface address/destination prefix
4.
Add or select a security zone; for example, Trust:
set security zones security-zone trust interfaces se-1/0/0.0 host-inbound-traffic
system-services all
5.
Add or select security zones for host inbound traffic protocol options:
Copyright © 2017, Juniper Networks, Inc. 72
SRX300 Series and SRX550 High Memory Gateway Interface Modules Reference