Juniper QFX10016, Руководство по оборудованию

Страница: 112 / 439

Table 41: Port Mapping for Channelization
ASIC Available Ports Disabled Port
PE0 0, 2, 4, 6, 8 6
PE1 1, 3, 5, 7, 9 7
PE2 10, 12, 14, 16, 18 16
PE3 11, 13, 15, 17, 19 17
PE4 20, 22, 24, 26, 28 26
PE5 21, 23, 25, 27, 29 27
To change from the default mode to 40-Gigabit Ethernet channelized mode, use the Junos OS
operational command set chassis fpc
slot-number pic 0 port port number channel-speed 10g.
Network Ports
Each of the 30 QSFP28 ports supports:
• 100-Gigabit Ethernet using QSFP28 optical transceivers. When a QSFP28 transceiver is inserted into
any of the ports, the QSFP28 port is enabled for 100-Gigabit Ethernet.
• 40-Gigabit Ethernet using QSFP+ optical transceivers. When a QSFP+ transceiver is inserted into any
of the ports, the QSFP+ port is enabled for 40-Gigabit Ethernet.
• QSFP+ to SFP+ direct attach copper breakout (DACBO) cables
On the QFX10000-30C-M, the ports are enabled by default, and the default configuration adds the
ports to the default VLAN.
Power and Status LEDs
The two LEDs to the left of the network ports indicate the power (PWR) and status (STS) for the line
card. See
Table 42 on page 102 and Table 43 on page 102 .
101