4. Slide the rear mounting-blades into the front-mounting brackets.
5. Attach the rear mounting-blades to the rear post by using the appropriate screws for your rack. Tighten the screws.
6. Ensure that the device chassis is level by verifying that all the screws on the front of the rack are aligned with the
screws at the back of the rack.
Connect Power to the Device
CAUTION:
Wrap and fasten one end of the ESD grounding strap around your wrist and connect the
other end to a site ESD point.
NOTE:
Ensure that you ground AC-powered systems by attaching one end of the grounding cable to earth
ground and the other end to the chassis grounding points.
To connect the device to the power supply:
1. Set the power switch on the device to the off (O) position.
2. Insert the power cord plug into the power source outlet and power cord coupler into the chassis power inlet.
3. Set the power switch to the on (|) position.
4. Verify that the power LED is lit green and on steadily.
Power Cable Warning (Japanese)
WARNING:
The attached power cable is only for this product. Do not use this cable for another
product.
6
