Juniper NFX150, Руководство по оборудованию

Страница: 80 / 152

•
1 mini-USB cable with Standard-A and Mini-USB Type- B (5-pin) connectors (not
provided).
To connect the NFX150 device to the console using Mini-USB Type-B console port:
1.
Connect the Standard-A connector of the mini-USB cable to the host machine (PC
or Laptop).
2.
Connect the Mini-USB Type-B (5-pin) connector of the mini-USB cable to the Mini-USB
Type-B console port (labeled
CON ) on the NFX150 device.
3.
Set the Mini-USB Type-B console port as the active console port by using the command
port-type
.
4.
Reboot the NFX150 device.
After the connection is established, the Mini-USB Type-B becomes the active console
port. The host machine connected to the Mini-USB Type-B console port displays log
messages and lets you control NFX150 device functionality through it.
See Also Connecting an NFX150 Device to a Network for Out-of-Band Management on page 77
•
Installing a Transceiver in an NFX150 Device
The transceivers for the NFX150 devices are hot-removable and hot-insertable
field-replaceable units (FRUs). You can remove and replace them without powering off
the device or disrupting device functions.
Before you begin installing a transceiver in an NFX150 device, ensure that you have taken
the necessary precautions for safe handling of lasers (see
“Laser and LED Safety
Guidelines and Warnings for the NFX150 Devices” on page 129 ).
Ensure that you have a rubber safety cap available to cover the transceiver.
To install a transceiver in a NFX150 device:
CAUTION: To avoid electrostatic discharge (ESD) damage to the transceiver,
do not touch the connector pins at the end of the transceiver.
1.
Remove the transceiver from its bag.
2.
Check to see whether the transceiver is covered by a rubber safety cap. If it is not,
cover the transceiver with a rubber safety cap.
Copyright © 2018, Juniper Networks, Inc. 80
NFX150 Network Services Platform Hardware Guide