Juniper MX480, Руководство по оборудованию

Страница: 331 / 420

CAUTION: Make sure that you open the ejector handle completely until
you hear it click. This prevents damage to the transceiver.
Use needlenose pliers to pull the ejector handle out from the transceiver.
6.
Grasp the transceiver ejector handle, and pull the transceiver approximately 0.5 in. (1.3
cm) out of the DPC, MPC, MIC, or PIC.
7.
Using your fingers, grasp the body of the transceiver, and pull it the rest of the way
out of the DPC, MPC, MIC, or PIC.
Figure 142: Removing SFPs or XFPs
8.
Place a rubber safety cap over the transceiver.
9.
Place the removed transceiver on an antistatic mat or in an electrostatic bag.
CAUTION: After removing a transceiver from the chassis, wait at least 30
seconds before reinserting it or inserting a transceiver into a different slot.
Installing an SFP or XFP Transceiver into an MX480 DPC, MPC, MIC, or PIC
To install an SFP or XFP:
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2.
Take each transceiver to be installed out of its electrostatic bag, and identify the slot
on the component where it will be installed.
331 Copyright © 2019, Juniper Networks, Inc.
Chapter 4: Maintaining Components