Juniper MX480, Руководство по оборудованию

Страница: 294 / 420

Figure 124: Removing the Septum
g005040
Remove four screws
on bottom.
MPC
Remove two
screws on top.
Slide septum
forward.
3.
If the MIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver
on the faceplate. Install a cap if necessary.
4.
Pull the ejector lever above both MIC slots away from the router.
5.
Align the rear of the MIC with the guides located at the corners of the MIC slot.
6.
Slide the MIC into the MIC slot until it is firmly seated in the chassis.
CAUTION: Slide the MIC straight into the slot to avoid damaging the
components on the MIC.
7.
Verify that the ejector levers are engaged by pushing them toward the router.
8.
If the MIC uses fiber-optic cable, remove the rubber safety cap from each transceiver
and the end of each cable.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
you are inserting or removing cable. The safety cap keeps the port clean
and prevents accidental exposure to laser light.
9.
Insert the appropriate cables into the cable connectors on the MIC.
Copyright © 2019, Juniper Networks, Inc. 294
MX480 Universal Routing Platform Hardware Guide