Juniper MX2010, Руководство по оборудованию, Страница: 61 / 825

Figure 10: Alarm Relay Contacts
g007406
1
Table 16: Alarm Relay Contacts
Description Label Function No.
The alarm relays consist of three terminal
contacts with a normal closed (NC),
common (C), and normal open (NO) relays
that signal a minor or major alarm when
broken.
MINOR ALARM–[NC C NO]
MAJOR ALARM–[NC C NO]
1
RELATED DOCUMENTATION
Disconnecting the Alarm Relay Wires from the MX2010 Craft Interface | 347
Connecting the Alarm Relay Wires to the MX2010 Craft Interface | 346
MX2010 Alarm LEDs and Alarm Cutoff/Lamp Test Button
Two large alarm LEDs are located at the upper right of the craft interface. When lit, the circular red LED
indicates a critical condition that can result in a system shutdown. A lit triangular yellow LED indicates a
less severe condition that requires monitoring or maintenance. Both LEDs can be lit simultaneously.
A condition that causes an LED to light also activates the corresponding alarm relay contact on the craft
interface.
To deactivate red and yellow alarms, press the button labeled ACO/LT (for “alarm cutoff/lamp test”), which
is located to the right of the alarm LEDs. Deactivating an alarm turns off both LEDs and deactivates the
device attached to the corresponding alarm relay contact on the craft interface.
Table 17 on page 36 describes the alarm LEDs and alarm cutoff button in more detail.
35