Juniper MX2010, Руководство по оборудованию, Страница: 406 / 825

3. Lift the extended DC cable manager slightly up while inserting the two flanges into the slots on both
sides of the DC PDM.
4. Push the extended DC cable manager into place.
5. Tighten the two captive screws to secure the extended DC cable manager.
Figure 181: Installing the Extended DC Cable Manager
g000034
D
Installing an MX2010 MIC
To install a MIC (see Figure 183 on page 393 ):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. If you have used a dual-wide MIC and are now replacing it with two single-wide MICs, install the septum
(see Figure 182 on page 391 ):
a. Place the MPC on a flat surface (if necessary, remove the MPC from the adapter card as described
in “Removing an MX2010 MPC from the Adapter Card” on page 528 .
b. Position the septum in the center of the MPC so that it lines up with holes labeled S on the top of
the MPC.
c. Insert a screw into each of the two holes labeled S, and then tighten them completely.
390