Juniper MX10008, Руководство по оборудованию

Страница: 166 / 361

SEE ALSO
Console Port Connector Pinouts for an MX10008 Router | 125
Configuring an MX10008 Router
You must perform the initial configuration of an MX10008 router through the console port using the
command-line interface (CLI).
Before you begin connecting and configuring the router, set the following parameter values on the console
server or PC:
•
Baud Rate—9600
•
Flow Control—None
•
Data—8
•
Parity—None
•
Stop Bits—1
•
DCD State—Disregard
To connect and configure the router from the console:
1. Connect the console port to a laptop or PC using the supplied RJ-45 cable and RJ-45 to DB-9 adapter.
The console (CON) port is located on the Routing and Control Board of the router.
2. Log in as root. A password is not required to log in as root. If the software boots before you connected
to the console port, you might need to press the Enter key for the prompt to appear.
login:
root
3. Start the CLI.
root@%
cli
4. Enter configuration mode.
root>
configure
5. Add a password to the root administration user account.
[edit]
root@#
set system root-authentication plain-text-password
167