Juniper Junos Space JA1500, Руководство по оборудованию

Страница: 78 / 210

NOTE:
• If you have specified that the Junos Space node is the first node in the fabric
or a standalone node, you can access Junos Space Network Management
Platform by typing the IP address configured for the Web GUI in a browser.
• If you have specified that the Junos Space node is part of an existing cluster
(fabric), then you must add the Junos Space node to the Junos Space fabric
using the Junos Space Network Management Web GUI. For more
information, see the Adding a Node to an Existing Junos Space Fabric topic
in the Junos Space Network Management Platform Workspaces Feature
Guide (available at
http://www.juniper.net/techpubs/en_US/release-independent/junos-space/index.html
).
Configuring Access to Junos Space Through a NAT Gateway
You can choose to configure access to Junos Space through a NAT gateway when you
are configuring a Junos Space appliance.
When prompted, specify whether you want to configure access to Junos Space using
NAT.
Do you want to enable NAT service ? [Y/N]
•
To configure NAT, type Y .
NOTE:
• If you choose to configure NAT, the options that are displayed depend
on the IP address or addresses that you have configured for the device
management interface. If you have configured eth3 as the device
management interface, then the options that are displayed will depend
on the IP address or addresses configured for eth3. If eth3 is not
configured, the displayed options will depend on the IP address
configuration of the eth0 interface.
• If the device management interface is assigned an IPv4 address, you are
prompted to enter the IPv4 address for the NAT interfaces. If the device
management interface is assigned an IPv6 address, you are prompted
to enter the IPv6 address for the NAT interfaces. If the device
management interface is assigned an IPv4 address and an IPv6 address,
you are prompted to select either IPv4, IPv6, or both for the NAT
interfaces.
•
If you are adding the node to an existing cluster and eth3 is configured,
you are prompted to specify whether you want to configure the trap
interface. You must choose to configure the trap interface, if you are
adding the node as the standby VIP node. If eth3 is not configured for
the node, you are not prompted to configure the trap interface.
Copyright © 2018, Juniper Networks, Inc. 64
JA2500 Junos Space Appliance Hardware Guide