Juniper JSA3800, Руководство по оборудованию, Страница: 79 / 92

Action to Take After an Electrical Accident
If an electrical accident results in an injury, take the following actions in this order:
1.
Use caution. Be aware of potentially hazardous conditions that could cause further
injury.
2.
Disconnect power from the device.
3.
If possible, send another person to get medical aid. Otherwise, assess the condition
of the victim, then call for help.
General Electrical Safety Guidelines and Warnings
WARNING: Certain ports on the device are designed for use as intrabuilding
(within-the-building) interfaces only (Type 2 or Type 4 ports as described in
GR-1089-CORE) and require isolation from the exposed outside plant (OSP)
cabling. To comply with NEBS requirements and protect against lightning
surges and commercial power disturbances, the intrabuilding ports must not
be metallically connected to interfaces that connect to the OSP or its wiring.
The intrabuilding ports on the device are suitable for connection to
intrabuilding or unexposed wiring or cabling only. The addition of primary
protectors is not sufficient protection for connecting these interfaces
metallically to OSP wiring.
CAUTION: Before removing or installing components of a device, connect
an electrostatic discharge (ESD) grounding strap to an ESD point and wrap
and fasten the other end of the strap around your bare wrist. Failure to use
an ESD grounding strap could result in damage to the device.
• Install the device in compliance with the following local, national, and international
electrical codes:
•
United States—National Fire Protection Association (NFPA 70), United States
National Electrical Code.
• Other countries—International Electromechanical Commission (IEC) 60364, Part 1
through Part 7.
•
Evaluated to the TN power system.
•
Canada—Canadian Electrical Code, Part 1, CSA C22.1.
•
Locate the emergency power-off switch for the room in which you are working so that
if an electrical accident occurs, you can quickly turn off the power.
79 Copyright © 2019, Juniper Networks, Inc.
Chapter 6: Safety and Compliance Information