Juniper CTP151 Platform, Руководство по оборудованию, Страница: 69 / 104

Removing a CTP Interface Module, Processor Module, or Clock Module
To remove a CTP module:
1. Issue the halt command.
2. Power off the CTP151 device.
3. Wrap and fasten one end of the ESD grounding strap around your wrist and connect the other end to
a site ESD point.
4. Use a Phillips screwdriver to loosen the captive screws located at the upper right and upper left of the
module panel.
5. Hold the captive screws and gently pull them outward to remove the module. See Figure 13 on page 62 .
61