Juniper Allegro 3 Base, Руководство пользователя

Страница: 16 / 50

12
Allegro 3 Rugged Handheld Powered by Android Owner’s Manual
CAUTION: Always power off the handheld before removing
the battery. Failure to do so may cause loss of data or
damage to the handheld.
1. Power off the handheld by holding the power button
until the Power Button menu appears and selecting
Power Off. Ensure that your unit is not plugged in to
external power.
2. Loosen the screws to the battery compartment, and
remove the door. The hand strap remains attached.
CAUTION: The Allegro 3 is not sealed against water and
dust when the battery door is not installed properly.
3. Remove the battery pack.
4. An image on the battery compartment label shows the
correct location and orientation for the SD card (slot on
the right). Push the card into the slot to insert it.
5. Replace the battery pack, and attach the battery door.
6. Power up the handheld.
Bluetooth
®
Wireless Communication
To create a partnership between the Allegro 3 and another
device with Bluetooth technology, follow these steps:
1. Turn both devices on.
2. Place them within at least 100 feet (30 meters) of each
other.
3. Make Bluetooth discoverable on both devices. Bluetooth
on the Allegro 3 is off by default. To activate it, go to
Settings > Bluetooth . You can also pull down the Quick
Settings Tray and tap the Bluetooth symbol to turn it on.
Tap the word Bluetooth underneath the symbol. A list of
discoverable devices is shown. Tap MORE SETTINGS to
go to the settings screen.
!
!