Jungheinrich ETX 513, Руководство по эксплуатации

Страница: 142 / 408

4.3 Preparing the truck for operation with an additional access code
(
o
)
Z
Optionally, the truck can be prepared for operation with an additional 5 digit access
code. Up to 99 different access codes can be set. The various access codes can be
assigned specific travel, steering and hydraulic programs (see page 258).
In addition to the access code the key switch / ISM access module (
o
) is still used to
switch on the truck.
Switching on the truck
Requirements
– Visual inspections and operations to be
performed before starting daily
operation, see page 124.
– Connect the battery to the truck.
– Insert and lock the battery latch.
– Insert and lock the side panels correctly.
– Close the battery cover, see page 78.
– Enter the operator position, see
page 128.
Procedure
• Turn the EMERGENCY DISCONNECT switch (9) to unlock it.
Z
Press the Emergency Disconnect (9) immediately if the truck starts to move or lift
as soon as it is switched on. Brief steering movements caused by steering
referencing are permissible.
• Switch on the truck, to do this:
• Insert the key in the key switch (8) and turn it as far right as it will go.
• Hold the card or transponder in front of the ISM access module (26) and
depending on the setting press the green button on the ISM access
module (26) (
o
).
8 9 26
140
04.19 en-GB