Jungheinrich EJE 220, Руководство по эксплуатации

Страница: 68 / 232

3.2 Preparing the truck for operation
Switching on the truck
Requirements
– Checks and operations to be performed before starting daily work, see page 67.
Procedure
• Pull the emergency disconnect switch (10) to unlock it.
• To switch on the truck:
• Insert the key in the key switch (14) and turn it as far to the right as it will go.
• Enter the code in CanCode (
o
) (56).
• Hold the card or transponder in front of the ISM access module and, depending
on the setting, press the green button on the ISM access module (
o
).
Z
The tiller (8) must be in the upper braking zone "B". If event message "E-0914" is
displayed on the CanDis display instrument (
o
) or on the display unit (2-inch
display) (
o
), move the tiller to the upper brake zone "B", see page 78.
The truck is ready for operation.
t
The charge status indicator (13) shows the current battery charge status.
o
The CanDis display instrument (54) or the display unit (2-inch display) (
o
) shows
the current battery charge status and the service hours.
8
10 13, 54 14, 56
68
04.19 en-GB