Switch actuator, 2-gang / blinds actuator, 1-gang
4.2 Commissioning
Commissioning the device
NOTICE!
Incorrect load control due to undefined relay state at delivery.
Risk of destruction of connected drive motors.
During commissioning, before switching on the load, ensure that all relay contacts
are open by applying the KNX bus voltage. Observe commissioning sequence!
￭
Switch on the KNX bus voltage.
￭
Wait about 10 s.
￭
Connect the load circuit.
Delivery state: The output is set as a blind output. Operation of the blind output possible
via input 1 (UP) and input 2 (DOWN). Input 3 has no function.
Function of Inputs in the as-delivered state
Input
Push-button (NO contact)
Function
1
Press briefly (< 0.4 s)
Stop
1
Press briefly (< 0.9 s)
Adjusting the slats UP
1
Press for a long time (> 0.9
s)
Raise
2
Press briefly (< 0.4 s)
Stop
2
Press briefly (< 0.9 s)
Adjusting the slats DOWN
2
Press for a long time (> 0.9
s)
Lower
3
---
---
Load physical address and application program
￭
For switched loads, configure the outputs as a switching output.
￭
For Venetian blind operation, configure the outputs as a Venetian blind output.
￭
In Venetian blind operation: measure blind/shutter and slat travel times and enter them in
the parameter setting.
￭
Press the programming button.
The programming LED lights up.
￭
Load physical address and application program using the ETS.
Safe-state mode
The safe state mode stops the execution of the loaded application program.
Only the system software of the device is still functional. ETS diagnosis functions and pro-
gramming of the device are possible.
Activating the safe-state mode
￭
Switch off the bus voltage or disconnect the device from the KNX.
￭
Wait about 10 s.
￭
Press and hold down the programming button.
￭
Switch on the bus voltage or connect the device to KNX. Release the programming button
only after the programming LED starts flashing slowly.
The safe-state mode is activated.
6 / 9
82404203
26.01.2021
J0082404203