Jung J630D, Руководство пользователя

Страница: 215 / 316

J630D
6. Dressers 26.7.02 209
– You can only correct the diamond length by displacing the diamond in the
holder. To do so, loosen the clamping screws a little, then adjust the position
of the diamond slightly by tapping it gently.
• In order to align the lateral position, you must first loosen the two fastening
screws of the single-diamond holder slightly.
• Then adjust the single-diamond holder to the required position by tapping it
gently.
– We recommend using a small copper pin to tap the holder.
• When the single-diamond holder is aligned exactly in position, tighten the clam-
ping screws again carefully.
• Now re-check the diamond.
• Adjust the other three diamonds in the same way.
– Adjust them in anti-clockwise order, i.e. 8 - 9 - 10.
Do not under any circumstances tap the diamond point!
Before you tap the single-diamond holder, swivel the dial gauge so
that it is positioned counter to the tapping direction.
When you adjust diamond no. 10, you will have to dismantle holder
no. 7, or you will not be able to loosen the clamping screws.
After you have re-mounted holder no. 7, you must align it again
laterally. Once adjusted, the single-diamond holders are not inter-
changeable.