Jung FM 1701 Series, Руководство по эксплуатации, Страница: 14 / 29

LB management
eNet radio centre plate
Parameters Setting options, Basic
setting Explanations
Deactivate twi-
light switching
state On, Off
Basic setting: Off Defines the behaviour of the output on deactivat-
ing the twilight function. Only visible when the pri-
ority for the twilight function is 0.
Invert switching
output On, Off
Basic setting: Off Inverts the switching output from NO contact
function (factory setting) to NC contact function
Minimum switch-
ing repeat time 100 ms ... 10 sec
Basic setting: 100 ms Limits the switching speed of the device by in-
creasing the value, in order to protect the load,
for example. Only when the set time has elapsed
is switching possible again. The last command
during the blocking time is executed after a delay.
The switching repeat time starts after each
switching operation.
Channel settings "dimming"
Parameters Setting options, Basic
setting Explanations
Switch-on bright-
ness 1...100 %
Basic setting: 100 % During brief operation, the output switches on at
the set switch-on brightness. Note: If the value is
above the set maximum brightness or below the
minimum brightness, then the system will switch
to the appropriate limit value.
Minimum bright-
ness 1...67 %
Basic setting: 5 % Specifies the minimum settable brightness. Note:
If parameters or scene values are set to a level
lower than the minimum brightness, then the sys-
tem will dim to minimum brightness.
Maximum bright-
ness 75...100 %
Basic setting: 100 % Specifies the maximum settable brightness. Note:
If parameters or scene values are set to a level
higher than the maximum brightness, then the
system will dim to maximum brightness.
Dimming adjust-
ment time 1…60 s
Basic setting: 4 s Time from minimum brightness until reaching
maximum brightness (dimming speed).
Switch-on delay 0 s … 24 h
Basic setting: 0 s The load switches on after a delay. Repeated
switch-on commands restart the delay time. If the
load has not yet been switched on due to the
delay when a switch-off command comes, then
the load will remain off.
Switch-off delay 0 s … 24 h
Basic setting: 0 s The load switches off after a delay. Repeated
switch-off commands restart the delay time. If the
load has not yet been switched off due to the
delay when a switch-on command comes, then
the load will remain on.
Dim up ramp 0 s … 24 h
Basic setting: 0 s Time between switch-on and reaching switch-on
brightness. The light is switched on at minimum
brightness and then dimmed to the switch-on
brightness. Only applies to switch-on with trans-
mitters (short operation). If scenes are recalled or
switching uses logic modules, the switch-on
brightness is approached using so-called soft
dimming (not configurable).
14 / 29
32597903 07.08.2019
J0082597903